![]() ![]() Wgb vlan Example: Device(config-wireless-policy)# wgb vlan ![]() Vlan vlan-no Example: Device(config-wireless-policy)# vlan 48 Wireless profile policy profile-policy Example: Device(config)# wireless profile policy test-wgbĬonfigures WLAN policy profile and enters the wireless policy configuration mode.ĭescription description Example: Device(config-wireless-policy)# description "test-wgb"Īdds a description for the policy profile. The profile-name is the profile name of the configured WLAN.Ĭcx aironet-iesupport Example: Device(config-wlan)# ccx aironet-iesupportĬonfigures the Cisco Client Extensions option and sets the support of Aironet IE on the WLAN. Wlan profile-name Example: Device(config)# wlan WGB_TestĮnters WLAN configuration submode. To enable the WGB to communicate with the root AP, create a WLAN and make sure that Aironet IE is enabled under the Advancedįollow the procedure given below to configure a WGB on a WLAN:įor WGB to join a wireless network there are specific settings on the WLAN and on the related policy profile.įor the configuration given below, it is assumed that the WLAN security is already configured.Ĭonfigure terminal Example: Device# configure terminal Wired clients connected to a WGB inherit the WGB's QoS and AAA override attributes. Therefore, we recommend that you physically secure the wired side of the WGB. Instead, the WGB is authenticated against the access Wired clients connected to the WGB are not authenticated for security. WGB, else server certificate validation may fail. If you want to use a chain of certificates, copy all the CA certificates to a file and install it under a trust point on the Session timeout is not applicable for wired clients. Idle timeout is not supported for both WGB and wired clients. MAC filtering is not supported for wired clients. Supported Access Points and RequirementsĬisco Aironet 2700, 3700, and 1572 SeriesĬisco Aironet 1800, 2800, 3800, 4800, 1562, and Cisco Catalyst 9105, 9115, and 9120, IW6300 and ESW6300 SeriesĬAPWAP image starting from Cisco AireOS 8.8 release. The following table shows the supported and unsupported authentication and switching modes for Cisco APs when connecting to Supported in all Wired-0, 1 and LAN ports 1, 2, and 3 Supported in Wired-0 and Wired-1 interfaces The following features are supported for use with a WGB: Table 1. The WGB establishes a single wireless connection to the root AP, which in turn, treats the Of its wired clients on the Ethernet interface and reporting them to the WLC through infrastructure AP using Internet Access A WGB connects a wired network over a single wireless segment by learning the MAC addresses ![]() Configuring Access Points as Workgroup BridgeĪ workgroup bridge (WGB) is an Access Point (AP) mode to provide wireless connectivity to wired clients that are connected.Verifying the Status of a Workgroup Bridge on the Controller.Authentication and Authorization Between Multiple RADIUS Servers.Enabling Syslog Messages in Access Points and Controller for Syslog Server.Predownloading an Image to an Access Point.Cisco Connected Mobile Experiences Cloud.Unscheduled Automatic Power Save Delivery.802.11 Parameters for Cisco Access Points.Converting Autonomous Access Points to Lightweight Mode.Overview of Cisco 9800 Series Wireless Controllers. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |